![]() SegmentingĬhunking videos into smaller sections is a MUST. Here’s how to add a note or audio note to put signaling into practice with Edpuzzle: 3. You can do this with phrases (heads up, remember, take note, etc.) or visually with on-screen text or graphics. Signaling is a way to direct students’ attention to important information. Here’s how to make cuts to your video with Edpuzzle: 2. Have you ever found the perfect video for your class, except it just goes into too much detail? Use the technique of weeding to remove any extraneous information.Īnd don’t worry about being ruthless – even if the video is entertaining, if a certain part doesn’t add to the educational content, feel free to cut it out. It’s a fact: shorter videos are better for student engagement. With these basic best practices, you can take the video-viewing experience from passive to active and effective! 1. It’s no secret that students love YouTube (and you probably do, too), but there is a better way to make YouTube and videos in general work for the classroom.Įxtensive research has been done into how to maximize engagement via video learning. If you’ve ever tried playing a YouTube video in class, you know what we’re talking about. So here are the results, by no means am i an expert and the results perfect but i think they are reasonable and show you can achieve good results given time, patience and the right tools for the job.Where video in the classroom is concerned, there’s a right way, and there’s a wrong way. These are from one of the makers of the Eichmann bullets(Keith Louis Eichmann) but i have to say the design is significantly better and they are much easier to work with having experience of both plugs. I terminated the cable with a pair of KLE Copper Harmony Plugs. I made the mistake of scrapping as much of the coating off as possible first using a razor blade - if you do this you risk losing a strand or two in the end so just use the soldering iron to melt it off then gently scrape off the residual scum.įor removing the outer jacket of the cable i found a scalpel allows much greater control than the stanley knife suggested.įor trimming away the unwanted copper shield at one end i actually found toe nail clippers to be very precise and easy to use if you dont have a pair of fine snips. I settled on 355c for melting the coating from each strand as well as making the connection to the RCAs.Īs always, good quality flux, a freshly tinned and cleaned tip and good preperation are essential for tinning the wire as well as making a good connection to the plug. ![]() Well it turns out the process and soldering temps are actually identical. ![]() He terminates AN Coppper Litz in the video but this left me wondering how it would be different for the AN silver litz given the horror stories ive heard regarding those delicate silver strands! Just thought i would jot down some thoughts on my experience terminating these wonderful sounding but delicate and fiddly cables.įirstly, if you are new to soldering, dont have a temp controlled soldering iron or are you are ham fisted and/or impatient then this is not the job for you.įirst step is to watch the excellent tutorial on youtube by Nick Lucas of HiFi Collective.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |